Make sure you have turned on notifications in your mobile phone and in the app. See the user manual for your intercom for more information. Make sure the intercom is correctly wired and configured. Make sure it has power and internet connection.Ĭheck that your client (computer or mobile phone) has internet connection. See the user manual for your recording device for more information. Go to Configuration in AXIS Companion and refresh the connection.Ĭheck that your recording media doesn’t report any errors. There are issues with the recording media, for example a missing SD card, faulty disk or incorrect configuration. Make sure IPv6 is enabled for your devices ( AXIS Companion uses IPv6 for communication). Check that the device/recorder has power and access to the internet. The device is no longer available on the network. If the attempt fails, hard reset the device and add it to the site again. If you click the link, AXIS Companion will try to repair the error. The device doesn't have the expected settings or is configured inaccurately. Make sure that the device is available on the network with valid network settings. If you click on the link that appears, AXIS Companion will try to repair the connection. The connection to the device is temporarily lost. See the troubleshooting section in the user manual of each individual camera at. Make sure that you don’t request too many streams from the cameras. Check that your devices have power and internet connection. The device can’t be accessed on the network. Make sure your graphic card is updated with the latest driver. Make sure your system follows the recommendations listed in System recommendations. For more information, see this FAQ.Ĭheck for incidents or scheduled maintenance of Axis services. Make sure that no firewall or antivirus software blocks the internet connection. Make sure the computer with your AXIS Companion client is connected to the network. The username and password combination is not valid. Make sure that required addresses are excluded from inspection and allowed by the firewall. The use of VPN or additional network security features block the connection to Axis services. Close the wizard, hard reset the device and start the wizard again. The device doesn’t have the expected settings, which prevents AXIS Companion from communicating with the device. Close the wizard and wait a few minutes before you restart it. The device is not available on the network after restarting, restoring or upgrading the firmware. Make sure you have internet connection and try again. Older Axis devices with a firmware that can’t be updated to 5.50 or later are not supported.ĪXIS Companion couldn’t contact the device. When you add your recorder to a site after a hard reset, you will be asked to type your encryption password to unlock the recorder, or to click Format disk to set a new password.Ĭheck that your devices have power and are connected to the same subnet as your computer. Reset your devices connected to the recorder. If no DHCP server is available on the network, the default IP address is 192.168.0.90 The product has been reset to the factory default settings. The process is complete when the status LED indicator turns green. Release the control button after 15-30 seconds when the LED indicator flashes amber.Ĭarefully put the recorder back in its place. Press and release the power button to start the recorder. Wait until the recorder is switched off, then turn it over to access the control button. Press the power button on the front of the recorder for 4-5 seconds until you hear a beep. A hard reset will not remove the encryption password.A hard reset will not remove your recordings.A hard reset will reset all the settings, including the IP address.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |